Yamaha CRW3200 series 24x burner

vbimport

#1

I've been having a problem w/ this burner and at least w/ nero. While using nero, which is my fav. burning software i normally start at 24x and it then lowers speed to 16x "due to media" Sometimes it stays at 24x. Ive tried many differnet type of cdrs speeds/brands and still have the problem. Anyone have an idea about whats up? I know a few have had the problem


#2

You never start at 24x. Your drive is a 18x-24x P-CAV and will never start at a higher speed than 18x.

Yamaha writers are picky if you insult them in using crap discs.

Use VDLP 24x (only if firmware 1.0e or later is installed) or Taiyo Yuden 24x.


#3

Fancy telling him to use firmware 1.0e there is no such firmware it only goes up to 1.0d at the moment.
bbock727 I think you had better post this over at CDRINFO they have a good Yamaha section on their Forum
You can get there by clicking on this link
http://www.cdrinfo.com/forum/


#4

Fancy telling him to use firmware 1.0e there is no such firmware

Ups. I really thought there is such a firmware…forgot to verify before posting :frowning:


#5

Or just at Yamaha themselves.

There is a 1.0e however for the 2200 series.