SATA switch in MTKFLASH (DOS)

Hi I’m wondering if someone could just give me a heads up on how to use the SATA switch at the command line argument in MTKFLASH. I have searched this and other forums and it’s pretty straightforward for everything else but I can’t seem to find an example of someone flashing SATA rather than IDE Drives.
I have a accidentally erased LiteOn iHas624-32 B that is not showing up automatically from start up.
my bin file is Lite.bin
I have the drive connected to Primary Sata (of 4 sata connections)
On boot to Dos I would have:
A:/MTKFLASH # W/B/M Lite.bin
all files in root of floppy

Where the(#) hash is would be 1,2,3,4 depending on IDE but as I am flashing to a SATA drive do I
/SATA
instead of the number or miss the number out and make it
A:/MTKFLASH /SATA/W/B/M Lite.bin
or is this wrong as well ?

A link to a SATA flashing example would be fine so I can see how it’s done. Cheers

Oh yea, which version do people suggest I start with 1.83c or 1.80.1 (I am aware “c” defalts to hex mode and the b switch is needed but not in 1.80)

Hello, Try DOSFlash 1.9, MTKFlash is very old utility,
Sometimes it need modify some hex code to support SATA controller,
DOSFlash is more SATA support for DOS utility, Good Luck

[QUOTE=wwkwoo;2586657]Hello, Try DOSFlash 1.9, MTKFlash is very old utility,
Sometimes it need modify some hex code to support SATA controller,
DOSFlash is more SATA support for DOS utility, Good Luck[/QUOTE]

Thanks will try