Problem Datawrite DVD-R Red V2 and LDW-411

Hello.

I’ve bought some DVD-R Datawrite Red V2, and my Liteon LDW-411 don’t recognize them.

I cannot even get the Code of the Media because sometimes the drive simply hangs and sometimes it says there’s no media inside… :frowning:

My firmware is FS0F.

Any ideas?

Thank you very much

If you’re only having the problem with this media, you have bad media (AN31 is known to be among the lowest of low end media available).

If it’s the media, return it to your store if possible. Recommended good quality media is RicohJPNR01, Taiyo Yuden -R and +R.

[B]
I’ve bought some DVD-R Datawrite Red V2, and my Liteon LDW-411 don’t recognize them.

I cannot even get the Code of the Media because sometimes the drive simply hangs and sometimes it says there’s no media inside… :frowning:

My firmware is FS0F.
[/B]

Try upraging your firmware to newer one (I personally recommend FS0H; gives better quality burns then than newer FS0J).
My 411S with FS0H recognizes them correctly as AN31 and gives a good quality burn.