PlexCombo 20/10/12A with DMA problems

hi.

i got this problem with my burner that when i burn anything with it using nero i goes to 4% then starts to lag a whole lot then continue to burn, still laging but no so much. so ive been told to set the drive to dma if available and that should fix the problem they say… but in my case it didnt :eek: , the drive is still set in pio mode.

i have asus a7v333 motherboard and a plexcombo 20/10/40A

plz respons asap :bow:

Setting it to DMA mode will fix the problem. Which Operating System are you running? If so check this thread, solving the dma problem in winxp!!

Welcome to the forum by the way :slight_smile: