Ok I found this today and it works like a charm i now we all had this Promblem we went to PIO mode not any more hassle and stuff like that.
Here is what causes the problem: For repeated DMA errors. Windows XP will turn off DMA mode for a device after encountering certain errors during data transfer operations. If more that six DMA transfer timeouts occur, Windows will turn off DMA and use only PIO mode on that device.
Now to the helpfull part here what u need to do.
Check Your IDE Port Mode
First check what mode your secondary IDE port is currently working in. Go to Device Manager: right-click on My Computer, select Properties, click on the Hardware tag, click on the Device Manager button, click on the plus sign to the left of IDE ATA/ATAPI Controller, double-click on the secondary IDE channel, click on Extended Settings and check whether it is set to DMA when available. Directly underneath that setting is a grey field that shows the actual working mode of your IDE channel. You want the highest possible DMA or Ultra DMA mode there, and you definitely don’t want PIO mode.
Normally you don’t have to use the registry editor for this, because the normal settings are also available through the properties dialog for the IDE port, but if you want to look at it anyway, the parameter for the secondary IDE port can be found through regedit.exe at
HKEY_LOCAL_MACHINE\HARDWARE\DEVICEMAP\Scsi\Scsi Port 1
It is named Scsi only for historic reasons. Scsi Port 0 is the primary IDE port, to which presumably your hard disk is connected.
After trying various remediesâ€”in vainâ€”I found the abovementioned article and went to work again. I uninstalled the DVD drive in Device Manager and rebooted, but that did not help either.
So I searched for more and better information, then I went on and did the following.
Re-enable DMA using the Registry Editor
My thanks go to my fellow MVP Alexander Grigoriev who taught me this method.
Run REGEDIT. Go to the following key:
It has subkeys like 0000, 0001, 0002, etc. Normally 0001 is the primary IDE channel, 0002 the secondary, but other numbers can occur under certain circumstances. You have to go through these subkeys and check the DriverDesc value until you find the proper IDE channel.
Delete MasterIdDataChecksum or SlaveIdDataChecksum, depending on whether the device in question is attached as master or slave, but it can’t actually hurt to delete both. Reboot. The drive DMA capabilities will be redetected.
Open Device Manager again and check whether the device is now actually using DMA mode. If so, congratulations, you’ve made it (at least until the next time Windows disables DMA).
Desensitize Your Computer’s IDE Channels
There’s a bit more to it. The following article offers a way to reduce the incidence of this problem, although it still doesn’t solve it altogether.
IDE ATA and ATAPI Disks Use PIO Mode After Multiple Time-Out or CRC Errors Occur
Do read this article because it contains a useful long-term workaround. But you have to go through the procedure described here to re-enable DMA first. Assuming you’ve done that, insert the ResetErrorCountersOnSuccess registry values mentioned in this article into both the primary and the secondary IDE port registry keys as described.
Unfortunately this is only a half solution, because when you enter an unreadable DVD, you will get 6 errors in a row, and the IDE channel will revert to PIO mode, but at least when you pull out the DVD in time and then insert a good one, the error counter will be reset and it will at least be a bit more difficult for Windows to hobble your IDE drive.
I dont take CREDIT for this but it Works please put a sticky on this.