Nero 7 Essentials burning DL 1st Time

Back in May I purchased a Lite-On 20X DVDRW Super-Multi Lightscribe LH20A1H DVD burner and it came with Nero 7 Essentials. This was a difficult program to get used to but I finally got it down. I can burn (single layer 4.7GB) DVD’s -R or +R without a problem, however I tried my first DL and a problem arose.

The burn process works fine on the first layer but the second layer causes an error. I used DVD Fab Decrypter to decrypt the DVD (the old TV show “Emergency”) onto my hard drive and it looks good.

Can I burn straight from Nero Essentials and eliminate the DVD Fab Decrypter step?

What would be causing the 2nd layer to error out?

I am using TDK DL’s.

What would be causing the 2nd layer to error out?

I am using TDK DL’s.

that would answer your question

I would use imgburn if I had to use dual layer

an old tv series I would just break up and burn to single layer tho

I agree with DaChew…but if you insist on Dl, then trust none other than Verbatim +R DL discs.

Ditto.

(the old TV show “Emergency”) onto my hard drive and it looks good.

ISO Read to ISO Write for DL.