Nec1100a

vbimport

#1

I have an nec-nd1100a boughten from tiger diredt and when i try to upgrade the firmware 1.93 from nec’s site it says target drive not found. I have tried it with drive set as slave and drive set to master and slaves disabled
same thing any suggestions?


#2

Is it on its own on the ide cable. The instructions with the firmware does say to make sure to disconnect other drives and set it as master.


#3

ok will disconnect other drive and try that thank you


#4

I disconnected the cdrw drive and uninstalled daemon tools which gives a virtual drive my nec drive is set to master and still get the target drive not found. _NEC DVD+RW ND-1100A [CD-ROM drive] is what i have.


#5

i used the binflasher gui in the saticky and it flashed fine :stuck_out_tongue: :bow: