ImgBurn 2 questions:

hi,
I had to reset defaults in ImgBurn and 2 things I can’t remember how to remove that are back on.

1] the E-Z picker that pops up when 1st opening the software.

2] After Imgburn searches then finds the blank media,
a info drop down screen pops with the pre- VideoTS stats in which I have to click ok before the burn starts and i Can’t remember where to un-check this .
was able to go from “search for media” right into the burning.

I found both those answers here last year but damn if I can find them in ImgBurn help.
thanks.

[QUOTE=rago88;2298501]hi,
I had to reset defaults in ImgBurn and 2 things I can’t remember how to remove that are back on.

1] the E-Z picker that pops up when 1st opening the software.

2] After Imgburn searches then finds the blank media,
a info drop down screen pops with the pre- VideoTS stats in which I have to click ok before the burn starts and i Can’t remember where to un-check this .
was able to go from “search for media” right into the burning.

I found both those answers here last year but damn if I can find them in ImgBurn help.
thanks.[/QUOTE]
here is how courtesy of StormJumper

http://club.cdfreaks.com/f116/6-0-1-0-unable-verify-disc-after-burning-275143/#post2283364

Also troy512 has a tutorial on youtube

ok…
got it…
thanks…
hey…
Has page “2” always been in the build mode page?
don’t remember it before…

Beef barley has a nice setup guide for Img also. Lots of screen captures.

[QUOTE=rago88;2298519]ok…
got it…
thanks…
hey…
Has page “2” always been in the build mode page?
don’t remember it before…[/QUOTE]
Nope page 2 is new

[QUOTE=signals;2298520]Beef barley has a nice setup guide for Img also. Lots of screen captures.[/QUOTE]
Never knew that, will do some searching to find it. Thanks

Can’t remember if it is in his sig or not. He regularly posts the links to it though.