Flash ND-3500 set as CS?

What’s the likelihood I will run into problems flashing my ND-3500 if it along with an ND-3100 are set to CS (Channel Select) on the primary IDE channel of my Dell XPS? I plan on using 2.1A. NEC’s instructions say to set the 3500 as Master and to disconnect all slave hardware. Has anyone had success / problems flashing to a CS connected drive?

No problems here. All 4 OD’s set to CS…

You got your best reliable answer form worker.

while i flash with both drives on the same cable it isn’t going to hurt anything to do so cable select really wouldn’t have any effect. once you boot up and the drives are assigned their master and secondary from their position on the cable they wouldn’t flip flop in the middle of a flash