I have a genuine
LiteOn LTR 40125S burner FW ZS03
LiteOn 163D DVD
CloneCD is my disc to disc copier and Nero
my Hard drive and VCD and Audio CD compiler.
I upgraded firmware directly to
VS06 which turned it into a
48125W with Mt Rainier and P-CAV
Copied Medal Of Honor with CloneCD 4 beta 8
with no problems and then an audio cd copy
of an original pressed cd with CloneCD with
again no problems
Ran Nero 126.96.36.199 to burn files from
my hard drive totalling 700M at 48X
using RITEK blank (rated 48X by SmartBurn
info program)and with SmartBurn On
which was going fine until about 97% when
had a large speed drop and took a while too finish
and when ran Scandisk from Nero Tools
there appeared a large amount of errors
toward end of CD.
Tried a 2nd CD with different batch of files
with hard drive defragged as before with same
behaviour and result with an exe file from the CD
unuseable and some problems reading some files
on the CD.
1. I would like to prevent these errors so would
you advise the best fw to avoid errors at 48x
2. If errors unavoidable what fw for the 40125S
or 40125W gives errorless burning with Mt Rainier & P-CAV
[B]3. If Nero is to blame can it be tweaked to prevent the errors ?
4.What other software could be used that doesnt have this problem ?[/B]
Sorry for the long post.
Scott another Aussie:D