Benq1650 problem

I just purchased a Benq1650, on my first burn,when it got to Imagburn the message on Imageburn was that there was “no writer detected”, also when using Nero disk info, the reply is
“no disk”. Any ideas?
T.I.A.

Is it listed in the Device Manager? Are you using a proper disc? Do you have the jumper set properly?

The first time you booted after installation did you see the little alligator in your taskbar saying that a new drive was detected?

Bougt it over the net, turns out it’s a Dvd Rom.

Then thats a V1650. Not a DW1650. I ahve made worse mistakes, I hope you didn’t pay too much for it.:doh: