Artec dhm-g48 read speed limits...:(



It’s labeled as being a 16x drive, as I’m sure you all know…but as I’m sure you’re also all aware of, it has problems reading at over 2.1x. Just flashed to 2.97, hoping it might do something…No such luck. It’s slave to my NEC ND-2500A…uhh that’s about it.

I’m just basically curious if there’s a firmware to get rid of the read speed limitations on the drive. Or if there was some way around it…? i’ve looked all over the internet for help on this matter, and haven’t found a single useful source yet…


make sure your drive is not in PIO mode. Change it to UDMA


it already is…any other ideas anyone?