1610 firmaware flashed on a 1394 external box



I flashed my new 1610 to B8T9 through a firewire cable in its external case, and it went all the way but right at the end of the flash it said it was interupted, and therefore failed, to try again. I did this twice and it said the same thing both times.
Im confused now because on every program that can ID the drive it says that it now has the B8T9 FW, and I burned a flick with it and it went fine, a 97% quality score on Ridata 8x but thats not unusual.
Should I take it out and flash it on an IDE cable or is it fine?


If it burned fine and the disc plays fine and it’s reading as the proper B8T9 firmware I’d say everything is ok. :wink: